Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 BMW 325is AutomaticFACTORY OEM SERVICE PROCEDURE
Mirror Function
- The vehicle ignition switch must be in ON/RUN position. The OFF/MIN/MAX sensitivity switch on mirror must be in MAX position.
- Test operation of ECTM Mirror by simulating glare as follows:
- In full daylight conditions, cover forward facing sensor (located on right side of mirror back) with a dark cloth or piece of opaque material. Hold dark cloth over sensor until you notice mirror start to darken.
- Remove cloth and mirror should return to clear state.NOTE: In low ambient light of a large workshop mirror may not return to full clear
- Repeat operation test several times to make sure mirror operates correctly.
- With mirror in dark, non-reflective stage, place gear selector into Reverse gear. The mirror should return to clear stage.
- Repeat previous step to make sure Reverse gear override operates correctly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.