Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Units
/F3) Behind center of dash. Lamp Control Module In front power distribution box. See Figure. On-Board Computer At center of dash. Relay Module In rear power distribution box. See Figure. Seat/Mirror Memory Control Module Under left front seat. Servotronic Control Module Behind left kick panel. Slip Control Module (ABS/ASC) In E-Box. Supplemental Restraint System Control Module Below left side of dash. Throttle Control Module (EML) In E-Box. Transmission Control Module (EGS) In E-Box. Wheel Camber Control Module Near right side of differential.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.