Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
QUICK TEST Function
QUICK TEST permits checking of defect codes on all control units with a self-diagnostic feature. Ignition switch must be turned to ON position before QUICK TEST is started. QUICK TEST is started from general overview of DME/Motronic control unit screen and is indicated by "QUICK TEST ACTIVE" in last (screen) line.
Control units are read out in same sequence as control unit overview. Progression of QUICK TEST is indicated to technician by flashing relevant line of control unit overview. Continuation to second page of control unit overview takes place automatically.
When BMW diagnostic software finds a control unit, corresponding line of DME/Motronic control unit overview is marked by an asterisk (*). If a defect code is stored in control unit, line is highlighted. QUICK TEST can be canceled at any time by pressing any key on BMW Service Tester. Completion of QUICK TEST is indicated by "QUICK TEST COMPLETED" in last (screen) line.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.