Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW1992325IS AUTOMATICREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENTSPECIFICATIONS & PROCEDURESWHEEL ALIGNMENT PROCEDURESTOE-IN ADJUSTMENTREAR (E46)
1992 BMW 325is Automatic
Rear (E46)
1992 BMW 325is AutomaticSECTION Rear (E46)
- Release screws approximately 1 1/2 turns at bearing pedestal. Attach special tool (32 3 030) to screw head and to notch (1). See Figure.
- Turn special tool and adjust toe-in to specification. See E46 under WHEEL ALIGNMENT SPECIFICATIONS.
- Tighten screws at bearing pedestal to specification. See E46 under TORQUE SPECIFICATIONS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.