Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW1992325IS AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 76 (COMPUTER RELEARN PROCEDURES - IMPORT)MAZDAREPROGRAM ERROR RECOVERY
1992 BMW 325is Automatic
Reprogram Error Recovery
1992 BMW 325is AutomaticSECTION Reprogram Error Recovery
WARNING: This page does not describe the selected car, but rather 164 other vehicles, including the 2002 Volvo V70, 2002 Volvo V40, 2002 Volvo S80, 2002 Volvo S60, and 2002 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Using first key, start engine. After SECURITY light illuminates for 1-2 seconds, turn first key to LOCK position. Using first key, turn ignition switch to ON position, then LOCK position 5 times. DO NOT leave key in either position for more than one second.
- Using first key, turn ignition switch to ON position. SECURITY light should illuminate. Turn first key to LOCK position and remove key. SECURITY light should go out.
- Using second key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn second key to LOCK position and remove key.
- Repeat step 3 with first key. Repeat step 3 with third key, then with each new key, up to 8 keys total. Waiting seconds will cause program to quit automatically. After reprogramming is complete, clear DTCs with NGS tester.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.