Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Operation Check
Turn ignition switch to ON position No. 1. SRS warning light should illuminate and then go out after 6-10 seconds if no fault codes are present. The following conditions indicate SRS is malfunctioning, and an SRS fault code will be stored in control unit memory:
- SRS light does not illuminate when ignition is turned on.
- SRS light does not go out after 6-10 seconds.
- SRS light remains on after engine is started.
- SRS light comes on or flickers while driving.
To read SRS fault code(s), see DIAGNOSIS & TESTING in AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIP section.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.