1990 BMW 325is StandardFACTORY OEM SERVICE PROCEDURE

Air Flow Measurement

The amount of air entering engine is measured by the air flow sensor. As intake air is drawn past the air flow sensor flap, the spring-tensioned flap opens and in turn actuates a potentiometer inside the sensor. The varying resistance of the potentiometer provides a varying voltage signal, which is approximately 0-5 volts, to the control unit that is proportional to the air flow. The air flow sensor also contains an intake air temperature sensor that measures the temperature of incoming air.

The throttle is operated by the accelerator pedal via the accelerator cable, and controls the amount of air drawn in by the engine. The throttle is adjusted during manufacture and does not require any routine adjustment. If the factory settings have been tampered with, then the throttle can be readjusted. The throttle switch is mounted to the underside of the throttle housing. Whenever the throttle is fully closed or fully open is when the throttle switch sends a voltage signal to the control unit.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.