1990 BMW 325is StandardFACTORY OEM SERVICE PROCEDURE

Output Signals

The MCU processes information from the input sensors and sends appropriate voltage control signals to control devices. For theory and operation of specific output components, refer to system indicated in parenthesis.

  • CHECK ENGINE Light (Self-Diagnostic System).
  • Fuel Evaporative Control Valve (Emissions Systems).
  • Fuel Injectors (Fuel Control).
  • Fuel Pump Relay, Main Relay and Oxygen Sensor Heater Relay (RELAYS).
  • Idle Speed Actuator (Idle Speed).
  • Ignition Coil (Ignition Systems).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.