1989 BMW 325is StandardFACTORY OEM SERVICE PROCEDURE

MOTRONIC Control Unit (MCU)

The MCU receives electronic input signals from several engine sensors. Information supplied by these sensors is used to determine optimum ignition and fuel injection timing, under various operating conditions. An air/fuel ratio of 14.7:1 is maintained under most driving conditions. MCU also controls fuel vapor purge from carbon canister.

NOTE: For ease of understanding, components are grouped into two categories. INPUT DEVICES are components which control or produce voltage signals that are monitored by MCU. OUTPUT SIGNALS are components that are MCU controlled.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.