1989 BMW 325is StandardFACTORY OEM SERVICE PROCEDURE

Throttle (Position) Switch

Throttle switch is located on intake manifold, opposite throttle linkage, below air intake hose to throttle body. Throttle switch determines throttle valve position. This information is converted into an electrical signal and is sent to the MCU. Switch incorporates idle switch and Wide Open Throttle (WOT) switch functions. MCU interprets signal as full throttle, idle or normal operating condition.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.