1989 BMW 325is StandardFACTORY OEM SERVICE PROCEDURE

Main Relay (Battery)

Activated by ignition switch, the main relay supplies power to MCU and other computer-controlled systems. On 325 Series, relay is located on left front shock tower. On 5 and 7 Series, relay is located in relay block, behind right front strut tower. On 635CSi, relay is located on outside of relay/fuse box on left side of engine compartment.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.