1988 BMW 735iL AutomaticFACTORY OEM SERVICE PROCEDURE

Coding, Individualization & Programming (CIP): Management: Notes

"Management"  can be selected from the main/initial CIP screen.

Fig 1: Selecting "Management" From Main/Initial CIP Screen (1 Of 2)
G03398026Courtesy of BMW OF NORTH AMERICA, INC.

Or

"Management"  can be selected from the Main CIP Selection screen.

Fig 2: Selecting "Management" From Main/Initial CIP Screen (2 Of 2)
G03398027Courtesy of BMW OF NORTH AMERICA, INC.

By selecting "Management" the following functions can be accessed:

  • Print previously performed Service Measure reports
  • Display the current version of CIP installed
  • Run a test on the software currently installed on the system (SSS)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.