1987 BMW L7 4HP22HFACTORY OEM SERVICE PROCEDURE

Test 8: Engine Speed Sensor & Reference Point Pick-Up

  1. Check sensor and pick-up general condition. Ensure that they are installed in proper position and firmly seated. Electrical contacts must be clean and tight. Check that sensor plugs are not reversed. Plugs are color coded for identification.
  2. Install BMW Test Meter (22 13 100 ). Connect terminals No. 8 and 27 and check for speed signal. Connect terminals No. 25 and 26 and check for reference signal. If signals are not correct, repair wiring. Remove terminal connections and recheck signals. If either signal is absent, replace sensor and/or pick-up as needed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.