1985 BMW 524tdFACTORY OEM SERVICE PROCEDURE

Fuel Injection Pump

The Bosch VP-20 fuel injection pump used on BMW 2.4L diesel engine is controlled by an electronic control assembly mounted in the luggage compartment. The control assembly processes information from the engine coolant temperature sensor, the position sensor and the lift sensor located in the No. 4 injector. Control assembly varies the injection timing according to this information. To change the injection timing, the control assembly controls the cycling of the fuel control solenoid in the injection pump. The solenoid varies the fuel pressure available to the advance piston by providing an additional pressure bleed and pressure at the advance piston. It therefore controls injection timing. The amount of fuel injected into the cylinders is not affected by the solenoid. The system has a built-in diagnostic capability which will light the "CHECK TURBO" warning indicator when there is a problem in the system.

Fig 1: Sectional View of Bosch Fuel Injection Pump
G35555
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.