1981 BMW 633CSi Automatic TransFACTORY OEM SERVICE PROCEDURE

Alternators - BOSCH: Description

Bosch alternators are conventional 3 phase, self rectifying type alternators. Nine rectifier diodes are connected to stator windings (3 to each phase lead). Diodes change alternator A.C. voltages to D.C. voltages coming out of the "B+" and the "D +" terminals of the alternator.

APPLICATION

Model Volts/Amps (1)Bosch Part No.
Audi
  4000
  Standard 14/55 469 520
  Heavy Duty 14/65 489 713
  California 14/35 469 502
  5000
  Gasoline & Diesel 14/35 469 502
  Gasoline Only 14/55 489 653
  Gasoline & Diesel 14/65 489 613
  All With A/C 14/90 489 514
BMW
  320i 14/65 489 718
  528i, 633CSi, 733i 14/65 489 619
Fiat
  Brava & Spider
  Standard 14/55 489 743
  With A/C 14/65 489 824
Mercedes-Benz
  240D 14/55 489 556
  280 Series 14/35 489 751
  300 Series 14/55 489 527
  300 Turbo 14/55 489 683
  380 Series 14/70 489 898
Porsche 924 14/75 469 502
Saab
  99 14/55 489 783
  900 14/55 489 735
Volkswagen
  Dasher
  Gasoline 14/55 489 622
  Diesel 14/55 489 520
  Calif. & All With A/C 14/65 489 713
  Jetta, Rabbit & Scirocco
  Standard 14/45 489 858
  With A/C 14/65 489 713
  Rabbit Diesel
  Standard 14/35 489 799
  With A/C 14/65 489 712
  Vanagon 14/65 489 913
Volvo
  Standard 14/55 400 933
  Heavy Duty 14/70 450 009
  Diesel 14/55 (2) 1257294
(1) Bosch part numbers are preceded by 0 120 for alternators. Integral regulator models are numbered 469 and 489, while separate regulator models are numbered 400 and 450.
(2) Volvo part number.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.