1981 BMW 320iFACTORY OEM SERVICE PROCEDURE

BOSCH Cis (Lambda) Fuel Injection: Description

The Bosch Continuous Injection System is a mechanical fuel injection system operated by incoming air flow. The Lambda system is a feedback control capable of measuring air/fuel ratios and correcting them constantly. The combination of the 2 systems makes it possible to obtain good economy and performance while minimizing exhaust emissions.

The system consists of the mixture control unit (air flow sensor and fuel distributor), control pressure regulator, auxiliary air valve, cold start valve, thermo-time switch, injector nozzles, fuel pump, filter, oxygen sensor, electronic control unit, frequency valve, and catalytic converter. Some models use additional components, such as a thermo-vacuum valve, hot start pulse relay, or a constant idle speed control system.

NOTE: Rabbit Pickup Federal models use the CIS injection system without oxygen sensor, so disregard oxygen sensor information for these vehicles.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.