1978 BMW 630CSi Automatic TransFACTORY OEM SERVICE PROCEDURE

Pressure Converter/Transmitter

  1. Start and run engine until normal operating temperature is reached. Ensure all vacuum hoses are connected properly.
  2. Disconnect Red hose from pressure transmitter and check for exhaust gas back-pressure at end of hose. If no pressure is felt, backpressure line or hose is leaking or plugged. Reconnect Red hose.
  3. Pull White hose from pressure transmitter and check for vacuum at end of hose. There should be vacuum. If not, check White hose and connections for leaks. Reconnect White hose.
  4. To check for control pressure on 630CSi, 633CSi and 733i, pull Red and Blue hoses from pressure transmitter. Vacuum should be felt at Blue hose fitting on transmitter. If not, replace pressure transmitter.
  5. To check for control pressure on 320i, disconnect Blue hose from pressure transmitter and check for vacuum at hose connection on transmitter. Vacuum should be felt. If not, replace pressure transmitter.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.