2025 Audi SQ5 Premium PlusFACTORY OEM SERVICE PROCEDURE

Pin Arrangements Distance Regulation Control Module 2 -J850

-T8s- (A) Designation
1 Terminal 31
2 Distance Regulation Control Module -J428- / Data-Bus wire (FlexRay-Bus)
3 Distance Regulation Control Module -J428- / Data-Bus wire (FlexRay-Bus)
4 Β 
5 Data Bus On Board Diagnostic Interface -J533- / Data-Bus wire (FlexRay-Bus)
6 Data Bus On Board Diagnostic Interface -J533- / Data-Bus wire (FlexRay-Bus)
7 Β 
8 Terminal 15
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.