Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2025 Audi S3 Premium PlusFACTORY OEM SERVICE PROCEDURE
Dynamic Ride Control (DRC), Checking
WARNING: This page is about a different car, the 2025 Audi S5 Sportback, 2025 Audi RS 5 Sportback, and 2025 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
| Start | ||||||
| Rattle coming from area of suspension or rear of vehicle while driving on rough terrain | Β | Strong side inclination of body while turning steering wheel | ||||
| β | Oil leakage detected? | β | ||||
| Β | β | Β | β | Β | ||
|
β Yes | Β | No β | Check all connections to central valves, shock absorbers and wiring harnesses. | ||
| β | Β | Β | β | |||
| β | Complaint eliminated? | |||||
| β | β | β | ||||
| β | No β | Yes β | ||||
| β | Check system pressure in both lines. | β | ||||
| β | Β | β | β | |||
| β | Β | System pressure larger than 14 bar | β | |||
| β | Β | No β | Yes β | β | ||
| Complete DRC line - extracting, evacuating and filling. Perform leak test. Refer to DYNAMIC RIDE CONTROL (DRC), DRAINING AND FILLINGΒ . | Complete DRC line - extracting, evacuating and filling due to possible air pockets. Perform leak test. Refer to (1)DYNAMIC RIDE CONTROL (DRC), DRAINING AND FILLINGΒ . | β | ||||
| β | β | β | ||||
| β | β | |||||
| β | ||||||
| End | ||||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
