2025 Audi S3 Premium PlusFACTORY OEM SERVICE PROCEDURE

Dynamic Ride Control (DRC) System Pressure, Checking

WARNING: This page is about a different car, the 2025 Audi S5 Sportback, 2025 Audi RS 5 Sportback, and 2025 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

  • DRC Pressure Tester :VAS 6209/2  , not illustrated
  • Hand Vacuum Pump :VAS 6213 
    Fig 1: Hand Vacuum Pump VAS 6213
    GWWW00-11210Courtesy of AUDI OF AMERICA, LLC

DRC Pressure Tester :VAS 6209/2  , Bleeding

Use only approved oil for the bleeding procedure. Refer to the Electronic Parts Information (ETKA).

NOTE:

The DRC Pressure Tester :VAS 6209/2  must always be bled the first time it is used.

If the DRC Pressure Tester :VAS 6209/2  still shows a residual pressure greater than 0.5 bar (for example, from a previous reading), bleeding must not be done.

-- To bleed pressure gauge -B- and line section -A-, install the special tool as shown.

Fig 2: Bleeding Pressure Gauge And Line Section
GWWA43-10070Courtesy of AUDI OF AMERICA, LLC
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.