Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Mount, Removing And Installing: Removing
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -2- for the Engine Coolant Level Sensor -G32-.
-- Remove the bracket -3- at the coolant expansion tank.
-- Release the catches -arrows- and remove the coolant expansion tank -1- and move to the side.
Audi A3 from MY 2021:
-- Remove the nuts -1 and 2- and remove the ground cable.
-- If equipped, remove the bolts -arrows- and place the bracket -1- to the side.
Continuation for All Vehicles:
-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .
-- Remove the bolts -arrows- and engine mount -1-.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.