Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Mount, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
-- Check the adjustment of the subframe mount. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .
-- Only remove the engine support, when the assembly mount bolts are tightened to tightening specification. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.