Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Multifunction Transmission Range Switch, Adjusting: Notes
Special Tools And Workshop Equipment Required
- Gauge - Multi Function Switch :T10173
Adjustment Requirements
- The Selector Lever Cable Is Removed From The Selector Lever.
- The Selector Shaft Is In "N".
- The Bolts For The Multifunction Transmission Range Switch -F125- Are Loosened.
- The Selector Lever Is Removed From The Selector Shaft.
Adjusting
-- Move The Selector Lever Into "N".
-- Insert The :T10173 On The Selector Shaft -2- And Rotate The Multifunction Transmission Range Switch - F125- -1- Until The Gauge Locks On The Multifunction Transmission Range Switch Connector Tab.
Tip:
If The Connector Tab Cannot Lock Into The Groove On The Gauge, Then The Transmission Is No Longer In "N". If This Is The Case, Shift The Transmission Into "N" Using The Gauge.
-- Secure The Gauge To The Selector Shaft -2- With The Bolt -3-.
-- Tighten The Bolts -Arrows-.
-- Remove The Adjustment Gauge.
-- Further Installation Is Performed In Reverse Order Of Removal. Refer To . Attach The Selector Lever -3- To The Selector Shaft -4-.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
