2025 Audi Q3 Premium PlusFACTORY OEM SERVICE PROCEDURE

ATF Level, Checking: Checking

-- Connect The Vehicle Diagnostic Tester And Identify The Vehicle In Guided Functions  .

-- Select Check ATF Level  .

  • Let The Transmission Cool Down If The Oil Temperature Is Higher Than 45° C (113° F).
  • The Engine Is Idling And The Selector Lever Is In "P".

-- Move The Drip Tray For Workshop Cranes Or :SMN372500  Under The Transmission Near The ATF Check Plug.

-- Remove The ATF Check Plug -Arrow-.

Fig 1: ATF Level Plug
GWWN37-0189Courtesy of AUDI OF AMERICA, LLC

-- Always Replace The Seal -Arrow- For The Bolt.

Fig 2: ATF Inspection Plug
GWWN38-0037Courtesy of AUDI OF AMERICA, LLC
  • Even If The Level Of Transmission Fluid Is Too Low, First A Small Amount Of Transmission Fluid Will Flow Out Of The Overflow Tube, Because It Fills During Operation.

ATF Flows Out Of The Overflow Tube.

Fig 3: Example Of Filler Tube As It Is Installed In Transmissions
GWWN37-0992Courtesy of AUDI OF AMERICA, LLC

-- Let The Excess Fluid Drain.

-- Install The Drain Plug With A New Seal As Soon As All The Fluid Has Drained Out (It Starts To Drip).

-- If No Transmission Fluid Comes Out, Then Fill.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.