2022 Audi S8FACTORY OEM SERVICE PROCEDURE

Brake Pedal Switch, Abs Control Module, Comfort System Central Control Module, Engine/Motor Control Module

GWW4N2-106321021Courtesy of AUDI OF AMERICA, LLC

F 

Brake Lamp Switch

FX2 

Brake Pedal Switch

G100 

Brake Pedal Position Sensor

J104 

ABS Control Module

J393 

Comfort System Central Control Module

J623 

Engine/Motor Control Module

T4ak 

4-Pin Connector, Black

T32k 

32-Pin Connector, Black

T46a 

46-Pin Connector, Black

T56e 

56-Pin Connector, Black, Green

T56f 

56-Pin Connector, Black, Black

384  Ground Connection 19 (in Main Wiring Harness)

639  Ground Connection on Left A-Pillar

B163  Positive Connection 1 (15) (in Interior Wiring Harness)

B335  Connection 54 (in Main Wiring Harness) 1

*  Diameter Depends on Equipment

*2  Not for Vehicles with Driver Assistance System

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.