2022 Audi S8FACTORY OEM SERVICE PROCEDURE

Control Module, Separating From Hydraulic Unit

  • The ABS Hydraulic Unit -N55- with the ABS Control Module -J104- must be removed in order to separate the control module and the hydraulic unit.
  • The return flow pump may not be removed from the ABS Hydraulic Unit -N55-.

Special tools and workshop equipment required 

  • ESD Work Surface: VAS6613 
    Fig 1: ESD Work Surface
    GWWW00-11877Courtesy of AUDI OF AMERICA, LLC

Procedure 

-- Remove the hydraulic control unit. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .

CAUTION:

There is a risk of destroying the control module through the electrostatic charge and reduced cleanliness.

- Discharge electrostatic charge: touch the electro-static discharge work surface

- Protect the inner control module from moisture and dirt.

-- Place the hydraulic unit with the control module on the ESD Work Surface: VAS6613  .

  • The control module -2- faces upward and the hydraulic unit -4- with the pump motor and connector -3- faces down.
    Fig 2: Identifying Hydraulic Unit
    GWWA45-10118Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and dispose of them.

-- Carefully remove the control module vertically upward without tilting.

  • Blowing the control module or hydraulic unit out with compressed air is not permitted.
  • The valve bodies inside the hydraulic unit must not be damaged or bent.

-- Cover the open hydraulic unit with a lint-free cloth.

-- Check the hydraulic unit sealing surface, and if necessary, clean with mineral spirits and a lint-free cloth.

-- A damaged sealing surface must not be mechanically reworked. A hydraulic unit with a damaged sealing surface must be replaced.

CAUTION:

There is a risk of damaging the control module through improper handling.

- Do not lift or remove the seal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.