2022 Audi S8FACTORY OEM SERVICE PROCEDURE

Chip Card Reader Control Module, Removing And Installing: Notes

The Chip Card Reader Control Module -J676- is located in the glove compartment, ER5.

If the Chip Card Reader Control Module - J676- is replaced, the following procedure applies:

-- Connecting and switching on the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

  • Diagnostic-capable systems
  • 005F - Information Electronics Control Module 1 - J794 (MIB 2+) or 005F - Information Electronics Control Module 1 - J794 (MIB 3)
  • 005F - Information Electronics Control Module 1, functions
  • 0642 - Chip Card Reader Control Module -J676 replacing

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.