2021 Audi SQ8 Premium PlusFACTORY OEM SERVICE PROCEDURE

ABS Control Module, Control Module for Adaptive Cruise Control, Data Bus on Board Diagnostic Interface, Engine/ Motor Control Module, Laser Distance Regulation Control Module

G00611603Courtesy of AUDI OF AMERICA, LLC

J104 -  ABS Control Module

J428 -  Control Module for Adaptive Cruise Control

J533 -  Data Bus on Board Diagnostic Interface

J623 -  Engine/Motor Control Module

J1122 -  Laser Distance Regulation Control Module

T8y -  8-Pin Connector, Black

T8z -  8-Pin Connector, Black

T14c -  14-Pin Connector, Black

T14cx -  14-Pin Connector, Brown

T46a -  46-Pin Connector, Black

T54a -  54-Pin Connector, Black

T56f -  56-Pin Connector, Black

T91a -  91-Pin Connector, Black

TSFVL -  Coupling Point on Left Front Bumper

* -  Refer to Applicable Engine Wiring Diagram

*2 -  For Vehicles with Adaptive Cruise Control (ACC)

*3 -  Depending on Equipment

*4 -  For Vehicles Without Adaptive Cruise Control (ACC)

*5 -  For Vehicles with 2.0L Gasoline Engine

*6 -  For Vehicles with Gasoline Engine

*7 -  For Vehicles with Diesel Engine

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.