Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Audi S8FACTORY OEM SERVICE PROCEDURE
Body Electrical: Wiring
- 97 Wiring
- Relay Panels, Fuse Panels And E-Boxes
- Component Location Overview - Relay Panels, Fuse Panels And E-Boxes
- Component Location Overview - Relay Panel, Instrument Panel, E-Boxes Engine Compartment
- Component Location Overview - Relay Panel, Fuse Panel, E-Boxes, Left FOOTWELL
- Component Location Overview - Relay Panel, Fuse Panel, E-Boxes, Right FOOTWELL
- Component Location Overview - Luggage Compartment Fuse Panel, 0K4
- Component Location Overview - Luggage Compartment Fuse Panel, 0K3
- Component Location Overview - Relay Panel And Fuse Panel In Luggage Compartment
- Overview - Main Fuse Panel
- Front Left Relay And Fuse Panel, Removing And Installing
- Coupling Point on Right A-Pillar, Bottom -TARU-, REMOVING AND INSTALLING
- Suppressor -C24-, REMOVING AND INSTALLING
- Wire Junction, Removing And Installing
- Wire Junction -TV1-, REMOVING AND INSTALLING, 0K4
- Wire Junction -TV1-, REMOVING AND INSTALLING, 0K3
- Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING
- Terminal 30a Wire Junction -TV3-, REMOVING AND INSTALLING
- Terminal 40 Wire Junction -TV66-, REMOVING AND INSTALLING
- Terminal 40 Wire Junction 2 -TV67-, REMOVING AND INSTALLING
- Fuse Panel F -SF-, REMOVING AND INSTALLING
- Relay And Fuse Panels Inside Luggage Compartment On Left Side, Removing And Installing
- Main Fuse Panel On Battery, Removing And Installing
- Component Location Overview - Relay Panels, Fuse Panels And E-Boxes
- Control Modules
- Component Location Overview - Control Modules
- Overview - Data Bus On Board Diagnostic Interface
- Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING
- Garage Door Opener Control Module, Removing And Installing
- Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING
- Connectors
- Connector Housings, Releasing And Disassembling
- Contact Surfaces, Cleaning
- Antenna Wires, Repairing
- Fiber-Optic Cable
- Vehicle Diagnostic Tester
- Relay Panels, Fuse Panels And E-Boxes
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.