2021 Audi S8FACTORY OEM SERVICE PROCEDURE

Instrument Cluster Control Module, Information Electronics Control Module 1, Windshield Projection Head Up Display Control Module

G00611325Courtesy of AUDI OF AMERICA, LLC

J285 -  Instrument Cluster Control Module

J794 -  Information Electronics Control Module 1

J898 -  Windshield Projection Head Up Display Control Module

T2jl -  2-Pin Connector, Black

T2jlx -  2-Pin Connector, Black

T2q -  2-Pin Connector, Black

T2rl -  2-Pin Connector, Black

T2u -  2-Pin Connector, Black

T10bf -  10-Pin Connector, Black

T12c -  12-Pin Connector, Gray

T18a -  18-Pin Connector, Black

TIM -  Coupling Point in Interior, Center

B159 -  Diagnostic Connection (in Interior Wiring Harness)

* -  For Vehicles with Windshield Projection

*2 -  Fiber Optic Cable

*3 -  For Vehicles with TV Tuner

*4 -  Depending on Equipment

*5 -  For Vehicles Without TV Tuner

*6 -  For Vehicles Without Windshield Projection

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.