Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Oil, Extracting
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit: SMN372500
Procedure:
-- Pull the oil dipstick or plug out of the guide tube.
-- Guide the oil extraction device extraction probe into the guide tube. Use a flexible extraction probe with the largest possible diameter and guide it in without using great force. Otherwise, the tip can get deflected at the bottom of the oil pan, causing a large amount of used engine oil to remain in the engine.
-- Extract all of the engine oil. Observe the operating instructions for the extraction device.
-- Then install the oil dipstick or plug.
Perform the oil change at operating temperature.
Follow all disposal regulations.
Pay attention to cleanliness.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
