Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
ABS Control Module, Control Module for Adaptive Cruise Control, Data Bus on Board Diagnostic Interface, Engine/ Motor Control Module, Laser Distance Regulation Control Module
J104 - ABS Control Module
J428 - Control Module for Adaptive Cruise Control
J533 - Data Bus on Board Diagnostic Interface
J623 - Engine/Motor Control Module
J1122 - Laser Distance Regulation Control Module
T8y - 8-Pin Connector, Black
T8z - 8-Pin Connector, Black
T14c - 14-Pin Connector, Black
T14cx - 14-Pin Connector, Brown
T46a - 46-Pin Connector, Black
T54a - 54-Pin Connector, Black
T56f - 56-Pin Connector, Black
T91a - 91-Pin Connector, Black
TSFVL - Coupling Point on Left Front Bumper
* - Refer to Applicable Engine Wiring Diagram
*2 - For Vehicles with Adaptive Cruise Control (ACC)
*3 - Depending on Equipment
*4 - For Vehicles Without Adaptive Cruise Control (ACC)
*5 - For Vehicles with 2.0L Gasoline Engine
*6 - For Vehicles with Gasoline Engine
*7 - For Vehicles with Diesel Engine
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
