Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Left/Right Peripheral Camera -R244- / -R245-, Removing And Installing: Removing
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Remove the mirror trim. Refer to MIRROR TRIM, REMOVING AND INSTALLING .
-- Remove the mirror adjustment unit. Refer to MIRROR ADJUSTMENT UNIT, REMOVING AND INSTALLING .
-- Release and disconnect the connector -3-.
-- Remove the screws -arrows-.
-- Remove the Left Peripheral Camera -R244- -1- with the bracket -2- from the exterior rearview mirror.
-- Remove the Left Peripheral Camera -R244- -1- from the bracket -2-.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.