2021 Audi Q8 Premium PlusFACTORY OEM SERVICE PROCEDURE

Control Module, Separating From Hydraulic Unit

Special tools and workshop equipment required 

  • ESD Work Surface: VAS6613 
  • Torx Bit T25: VAS5377 
  • Only replace the control module if the control module is faulty.
  • If the hydraulic unit is faulty, the hydraulic unit and the control module are to be replaced together.

Procedure 

-- Remove the ABS Control Module -J104- /ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .

CAUTION:

There is a risk of destroying the hydraulic unit by removing the return flow pump.

- Never separate the return flow pump from the hydraulic unit.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.