Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Module, Installing On Hydraulic Unit
Special tools and workshop equipment required
- Torque Screwdriver: VAG1624
- ESD Work Surface: VAS6613
- Torx Bit T25: VAS5377
Procedure
Use the complete repair kit when installing.
A new control module may be installed a maximum of three times to a used hydraulic unit to ensure that the elastic seal seals sufficiently.
Do not install a used control module.
Excessive shaking (for example, dropping, impact) may destroy the control module. The control module must then no longer be used.
The hydraulic unit threads cannot be re-cut to secure the control module. If the thread is damaged, the hydraulic unit must be replaced.
If the bolts are difficult to install by hand or cannot be tightened to the tightening specification, then the thread is damaged.
If the ABS Control Module -J104- /ABS Hydraulic Unit -N55- is being replaced, select the function on the Vehicle Diagnostic Tester.
-- Check the cleanliness of the hydraulic unit sealing surface if necessary clean with mineral spirits and a lint-free cloth.
- The hydraulic unit -4- with the pump motor and the connector -3- faces down.
-- Place the control module -2- carefully from above on the hydraulic unit without tilting.
-- Install the new bolts -1- by hand until the control module touches the hydraulic unit evenly.
Replace the hydraulic unit if the bolts for the control module on the hydraulic unit are difficult to install or cannot be tightened to the tightening specification.
-- Tighten the bolts in two stages in a diagonal sequence.
-- Install the hydraulic control unit. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
-- Code the ABS Control Module -J104- using the Vehicle Diagnostic Tester. A basic setting must be performed at the same time.
Tightening Specifications
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
