Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Audi Q5 e PremiumFACTORY OEM SERVICE PROCEDURE
Coolant Temperature Sensor: Remove & Replace
FUEL INJECTION - ELECTRONIC
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Engine,Rear,G62 | 1.5 | B | ||
| Front,G83 | 0.9 | B | ||
| Hybrid Cooling System,G898/G899,Both | Includes: Additional time for use of scan tool to perform this procedure. | 2.5 | B | |
| Hybrid Cooling System,G898/G899,One | Includes: Additional time for use of scan tool to perform this procedure. | 2.3 | B | |
| Hybrid Cooling System,G902 | Includes: Additional time for use of scan tool to perform this procedure. | 1.3 | B | |
| Hybrid Cooling System,G903 | Includes: Additional time for use of scan tool to perform this procedure. | 1.1 | B | |
| Hybrid Cooling System,G904 | Includes: Additional time for use of scan tool to perform this procedure. | 1.1 | B | |
| Hybrid Cooling System,G905 | Includes: Additional time for use of scan tool to perform this procedure. | 1.0 | B | |
| Hybrid Cooling System,G906 | Includes: Additional time for use of scan tool to perform this procedure. | 1.3 | B | |
| Hybrid Cooling System,G907 | Includes: Additional time for use of scan tool to perform this procedure. | 1.0 | B | |
| Hybrid Cooling System,G908 | Includes: Additional time for use of scan tool to perform this procedure. | 1.0 | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.