Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Audi Q3 Premium PlusFACTORY OEM SERVICE PROCEDURE
Component Location Overview - Inner Control Modules
- Bracket
- For vehicle electrical system control module
- Overview. Refer to COMPONENT LOCATION OVERVIEW - A-PILLAR RELAY PANEL AND INSTRUMENT PANEL FUSE PANEL .
- Guide
- For the center connector
- Vehicle Electrical System Control Module -J519-
- Removing and installing. Refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING .
- Data Bus on Board Diagnostic Interface -J533-
- Overview. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Bracket
- For the control module
- Overview. Refer to COMPONENT LOCATION OVERVIEW - RELAY PANELS, FUSE PANELS AND E-BOX .
- Control Module
- Equipment version with parking aid: Parking Aid Control Module -J446-
- Equipment version with parallel parking assist: Parallel Parking Assistance Control Module -J791-
- Removing and installing. Refer to PARKING AID CONTROL MODULE -J446-, REMOVING AND INSTALLING .
- Cover
- For the control module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
