2019 Audi A3 TitaniumFACTORY OEM SERVICE PROCEDURE

Windshield Projection Head Up Display Inner Bracket, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi SQ5, 2020 Audi Q5 e, 2020 Audi Q5, 2019 Audi SQ5, and 2019 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- A control module that has fallen down cannot be used again.

- When inserting the control module, never apply pressure on the housing upper section.

-- Check the control module function.

  • A number must be visible on the windshield.

-- Calibrate the windshield projection control module. Refer to WINDSHIELD PROJECTION HEAD UP DISPLAY CONTROL MODULE, CALIBRATINGΒ .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.