2019 Audi A3 TitaniumFACTORY OEM SERVICE PROCEDURE

Windshield Projection Head Up Display Control Module, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi SQ5, 2020 Audi Q5 e, 2020 Audi Q5, 2019 Audi SQ5, and 2019 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

-- Remove the upper cover -2- from the instrument panel -1- using the : T10383/1Β  .

GWWA90-10273Courtesy of AUDI OF AMERICA, LLC

-- Cover the control module -3- with a soft towel.

GWWA90-10323Courtesy of AUDI OF AMERICA, LLC
CAUTION:

There is a risk of destroying the windshield projection head up display control module.

- Only remove the designated bolts from the control module.

- Never remove the bolts for the housing upper section.

-- Remove the bolts -1, 2, 4-.

-- Lift the control module slightly and disconnect the connector.

-- Remove the control module.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.