Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Night Vision System Control Module, Removing And Installing, Through 11/6/2016: Removing
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the front sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .
-- Loosen the left front seat and, with the wires still attached, push it toward the rear. Refer to OVERVIEW - FRONT SEAT\ .
-- Remove the floor mat.
-- Disengage the carpet and push aside.
-- Remove the nuts -arrows- from the bracket -1-.
-- Release and disconnect the connectors -2- from the Night Vision System Control Module -J853-.
-- Remove the Night Vision System Control Module -J853- with the bracket -1-.
-- Remove the screws -3- and remove the Night Vision System Control Module -J853- -1- from the bracket -2-.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.