Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Audi A4 PremiumFACTORY OEM SERVICE PROCEDURE
Pedestrian Protection Sensor: Remove & Replace
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Lower,w/Lane Departure System,w/Adaptive Cruise Control | Includes: Additional time for use of scan tool to perform this procedure. Includes: Adjust Camera. Includes: Adjust Radar Sensor. DOES NOT include wheel alignment. | 3.1 | C | |
| Lower,w/o Lane Departure System,w/o Adaptive Cruise Control | 1.2 | C | ||
| Upper,Left,Center,Right | 0.6 | C |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.