Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Audi S6 Premium PlusFACTORY OEM SERVICE PROCEDURE
Overview - Dynamic Steering
NOTE:
Dynamic steering = active steering
- Active Steering Control Module - J792-
- The basic setting must be performed on the system if the Active Steering Control Module - J792- was replaced. Refer to Dynamic Steering Basic Setting .
- Removing and installing. Refer to Active Steering Control Module - J792-, Removing and Installing .
- Steering Column
- Removing and installing. Refer to Steering Column, Removing and Installing .
- Safety Lock for Active Steering
- Removing and installing. Refer to Active Steering Safety Lock (Locking Magnet), Removing and Installing. .
- Actuator
- The actuator and steering column are one component and are replaced together.
- Must not be loosened or removed from the steering column.
- Perform a basic setting on the system if the actuator was replaced. Refer to Dynamic Steering Basic Setting .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.