Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Audi R8 BaseFACTORY OEM SERVICE PROCEDURE
Rear View Camera System Control Module -J772-, Connector Views
8-PIN CONNECTOR -T8AB-
| T8AB (A) | Designation |
|---|---|
| 1 | Terminal 15, from Fuse Carrier 2ST2 in Fuse Panel C SC |
| 2 | |
| 3 | |
| 4 | Extended System CAN-Bus High, to B108 CAN-Bus Extended High Connection 1 (in main wiring harness) |
| 5 | Terminal 31, to 626 Right tail lamp ground connection |
| 6 | |
| 7 | |
| 8 | Extended System CAN-Bus Low, to B109 CAN-Bus Extended Low Connection 1 (in main wiring harness) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
