Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Audi R8 BaseFACTORY OEM SERVICE PROCEDURE
Coolant Fan Control Module -J293-/Coolant Fan Control (FC) Control Module 2 -J671-, Connector Views
4-Pin Connector -T4V-/4-Pin Connector -T4Y-Β
| T4v (A) | Designation |
|---|---|
| 1 | Terminal 30, from Coolant Fan Single Fuse S42 on cover for main fuse carrier |
| 2 | Terminal 87, from Fuse Panel A SA |
| 3 | Fan stage, from Engine Control Module J623 |
| 4 | Terminal 31, to 671 Ground Connection 1 (on left front long member) |
| 1 | Terminal 30, from Coolant fan second speed fuse 2S104 Cover for main fuse carrier |
| 2 | Terminal 87, from Fuse Panel A SA |
| 3 | Fan stage, from Engine Control Module J623 |
| 4 | Terminal 31, to 685 Ground Connection 1 (on right front long member) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
