Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Audi R8 BaseFACTORY OEM SERVICE PROCEDURE
Rear View Camera System Control Module -J772-, Connector Views
20-PIN CONNECTOR -T20A-
| T20A C) | Designation |
|---|---|
| 1 | |
| 2 | |
| 3 | |
| 4 | |
| 5 | |
| 6 | |
| 7 | |
| 8 | |
| 9 | Rear View Camera R189 |
| 10 | Terminal 30, from Fuse Carrier 6 ST6 in Fuse Panel C SC |
| 11 | CAN-Bus Instrument Cluster, Low, to B709 Instrument cluster CAN bus low connection 1 (in main wiring harness) |
| 12 | CAN-Bus Instrument Cluster, High, to B708 Instrument cluster CAN bus high connection 1 (in main wiring harness) |
| 13 | |
| 14 | |
| 15 | |
| 16 | |
| 17 | |
| 18 | |
| 19 | Rear View Camera R189 |
| 20 | Terminal 31, to 35 Ground Connection (below front passenger's seat) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
