Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Number/Engine Specifications
Engine Number
The engine number can only be seen with the engine cover removed.
- The engine number ("engine code" and "serial number") is located on the front of the cylinder block at the top -arrow-.
- Engine codes beginning with "C" are four letters long.
- The first three positions of the engine code stand for displacement and the mechanical engine structure. They are stamped in the cylinder block, including the serial number.
- The fourth position represents the engine output and torque and is dependent on the engine control module.
- Refer to the Maintenance Tables for the allocations of the engine codes.
The four digit engine code is on the type plate (market-specific), vehicle data label and engine control module.
Component locations of the type plate (market-specific) and vehicle data label. Refer to VEHICLE DATA LABEL .
Engine Specifications. Refer to ENGINE OVERVIEW [CREC] .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
