Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 PlusFACTORY OEM SERVICE PROCEDURE
Rear Suspension: Spring: Remove & Replace
DOES NOT include wheel alignment (unless noted otherwise).
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Rear,Both,w/o Sun Blind | 4.5 | B | ||
| Rear,Both,w/Sun Blind | 5.4 | B | ||
| Rear,One Side,w/o Sun Blind | 3.6 | B | ||
| Rear,One Side,w/Sun Blind | 4.3 | B | ||
| Combination Procedure: AIR SUSPENSION SYSTEM: Drain & Refill: | ||||
| With Use of Scan Tool. | 0.3 | B | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.