Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Sunload Sensor: Removal
WARNING: This page is about a different car, the 2017 Ford Expedition and 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
Expedition, Expedition EL vehicles
- 1.
Remove the sunload sensor.- Detach the sunload sensor from the instrument panel.
- Disconnect sunload electrical connector and remove the sunload sensor.
Navigator, Navigator L vehicles
- 2.
Remove the Front Controls Interface Module(FCIM). Refer to, Information and Entertainment Systems - AM/FM/CD , Information and Entertainment Systems - 4.2-Inch (107 mm) Screen, AM/FM CD Sync , Information and Entertainment Systems - Sony Audio System or Information and Entertainment Systems - THX Audio System .
- 4.
Remove the instrument panel center bezel.- Remove the screws and position aside instrument panel center bezel.
- Disconnect the sunload sensor electrical connector.
- Remove the instrument panel center bezel.
- Tighten to 2.5 Nm (23 lb-in).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
