Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Section 558 (Instruments)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
- 90 Instruments
- Instrument Cluster
- Overview - Instrument Cluster
- Overview - Windshield Projection (Head Up Display)
- INSTRUMENT CLUSTER WITH Instrument Cluster Control Module -J285-, REMOVING AND INSTALLING
- Instrument Cluster Multi-Pin Connector Contact Assignment
- Fuel Level Sensor Connector Assignment
- Engine Coolant Temperature Sensor Connector Assignment
- Outside Air Temperature Sensor, Removing And Installing
- Windshield Projection Head Up Display Control Module, Removing And Installing
- Windshield Projection Head Up Display Control Module, Calibrating
- Clock
- Horn
- Special Tools
- Instrument Cluster
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.