2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE

Pinpoint Test Purpose

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

To verify PSCM U3000:XX is present and provide diagnostics if DTC U3000:XX is currently present and active in the PSCM.

NOTE: If a damaged bellows boot(s) was discovered during Inspection and Verification and this pinpoint test DOES NOT lead to the installation of a new EPAS gear or bellows boot(s), then GO to PINPOINT TEST K  to address the damaged boot(s) before returning the vehicle to the customer.
  1. BT1: RETRIEVE PSCM DTCS 
    • Ignition ON, engine running.
    • Carry out the PSCM self-test.
    • Is DTC U3000:4B currently present and active in the PSCM? 
      Yes No
      GO to PINPOINT TEST BU . If DTC U3000:XX is not currently present and active in the PSCM.
      No fault found.
      DISCONTINUE this pinpoint test and REFER to the PSCM DTC Chart for direction.
      For all other PSCM U3000:XX DTCs, Go to  BT2.
  2. BT2: CHECK THE PSCM FOR RETURNING DTCS 
    • Ignition ON, engine OFF.
    • Clear the PSCM DTCs.
    • Ignition OFF.
    • Wait at least 90 seconds for the modules to completely shut off.
    • Ignition ON, engine running.
    • Carry out the PSCM self-test.
    • Is DTC U3000:xx present in the PSCM? 
      Yes No
      INSTALL a new EPAS gear.
      REFER to POWER STEERING SYSTEM .
      ORDER a replacement EPAS gear and INCLUDE the RVC on the order form.
      If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
      If the PSCM does not list DTC U3000, DISCONTINUE this test and REFER to the DTC Chart for direction. If other modules are reporting DTC U3000, REFER to the reporting module DTC Chart.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.